Hi everyone. Since upgrading to fibre 75, my door camera is now unable to connect. Previously, my broadband had an extra partition of 2.4 ghz. It now doesn't have this partition, which was needed to connect the camera. Any help/advice would be appreciated.
@GeordieJohn72 Did you change the sky hub on your fibre upgrade and which hub do you have now and previous, see the link below abot the current ones! Also did the hub move by far when you did the upgrade and where your new ONT was positioned!
I have the black router. I didn't change it's position. The guys who fitted the fibre said it was well placed. The problem is that I am unable to find a 2,4 ghz partition anymore. The upgrade is brilliant. Just this one problem is all. Thanks for responding.
@GeordieJohn72 Did you look at the link, they are all black apart from 2 off them will assume you have the sky Broadband Hub, as full fibre and talk requires that one, so linked below about the split bands for you on that hub!
Yes. The sky engineers went through this detail with me whilst doing the work. Im quite prepared to consider that the camera is at fault and not the fibre. Just unable to find the 2.4 partition anymore is all. Thanks again for your interest.
Just bought a new door camera. It too cannot connect to the 2.4 ghz portal. Don't know what to do now. Checked the router online. There is a 2.4 ghz portal, synced with a 5 ghz portal.
@GeordieJohn72 Your were sent the information link on post 4, did you not see it did you just skipped it!
If your installation Engineer reset you sky Hub when he changed the position then it defaults to what is on the label back off the sky Broadband Hub! Split band;s no longer and back to a single ssid!
