16 Nov 2022 07:24 PM
This was installed 9 days ago, I've got the Ultrafast package with a supposed download speed of 145Mbps.
I've been monitoring the speeds, a few times a day & night, the upload speed has been a consistant 28Mbps, however, the download speed has flucuated between 79 & 94 Mbps, with 46 measurements averaging 89Mbps. Tested via a Cat6 cable between my PC & the router & using Speedtest by Ookla & fast.com, with only smart bulbs/plugs sharing the bandwidth.
The router no longer reports the broadband link connection speed.
I'm aware of the up to 14 testing period, but Openreach (working next door) have informed me that the speed should have been higher at some points, like nearer to 145Mbps.
If it stays at this 89Mbps average, I'll get 2 months for free, because of the gaurentee, but it's not the service I'm paying for: upto 145Mbps isn't 89, 120, yeah acceptable.
I'm getting a bit concerened as I approach the 14 day cooling off period is vastly approaching.
Apart from a call to Sky to cancel, is there anything else I can do?
Cheers.
17 Nov 2022 07:19 PM
Thanks both for your help.
I've fixed the issue.
Openreach installed the fibre last week, he asked if I had an ethernet cable to go to the router, because there wasn't one in the box with the ONT, & asked if one should be provided, he said yes, then went & got one from his van, I'd just assumed, him being a network engineer, that he knew what he was doing.
I was wrong, he had fitted a Cat5 cable.
I just had a eureka moment & checked the only thing I hadn't previously checked & fitted a Cat6 from the ONT to the router.
Bang! 150Mbps on my phone & that's on WiFi, with 28 other devices still attached, just as it should be.
So due to my "irrelevant" knowledge & skills, I've sorted out my problem, that Openreach caused.
I'll again apologise to you both for my unintentional harsh tone, as explained above.
Cheers.
17 Nov 2022 07:43 AM
Posted by a Superuser, not a Sky employee. Find out more@ChrisKJ it is possible that there is an issue with your connection being restricted at Sky's end but it is unlikely. To prove it is an issue at Sky's dnd your speed test needs to be run under controlled conditions which are use a device which is connected by gigabit ethernet directly to the hub and when no other device is using bandwidth. Then you should see speed tests around 145Mb/s as Openreach suggested.
If the result is still low call Sky and report the issue but also post your result here as one of the Superusers can add you to a thread in our closed forum Skybstaff can see.
Tests report the slowest part of the transfer so often just report the wifi speed in your home hence the requirement to use ethernet.
17 Nov 2022 12:03 PM
Posted by a Superuser, not a Sky employee. Find out moreCan you post your router stats for us? Ideally can you post one set without you using the connection and then another midway through a speedtest
17 Nov 2022 05:11 PM
This isn't about WiFi.
If you re read my post, I'm connected via Cat6 from my PC directly to the router.
Yes, I do have a few smart plugs & bulbs connected, but there is no way, it's not even possible, that they are using the lost 55Mbps, they use a few Kbps, at the very most.
I've used various software applications such as, but not limited to, Speedtest by Ookla, Wireshark & CMD.
All are reporting the same speeds.
This isn't a problem at my end, I've got a degree in computer science & know how to test correctly.
17 Nov 2022 05:17 PM
The SR203 router no longer reports the downstream connection or speeds, since being connected to the Openreach ONT.
17 Nov 2022 05:25 PM
Posted by a Superuser, not a Sky employee. Find out more@ChrisKJ if you had read my post the reason for running the test in the way I asked and posting it is so we can add to the list of cases. Your qualifications are irrelevant but you should know running tests under controlled conditions is fundamental to establishing the cause. However as you know best suggesst you call Sky and hope they listen.
17 Nov 2022 05:30 PM
Posted by a Superuser, not a Sky employee. Find out moreIm not looking for your connection stats I'm looking for the live Tx & Rx when your network is 'Idle' and then are running the speedtest to see if that bandwidth is making it through your WAN connection and whether there is any idle devices using bandwidth in the background.
I appreciate you may be tech minded and have a good understanding of how to look at these problems but its a bit silly post on a forum asking for help and then snap back at anyone who offers advice or to see some network test results.
17 Nov 2022 05:41 PM
Like I said, I've run all the tests possible, from my end. In the last 10 days, all under controlled industry standard conditions.
I appreciate your input & apologise for my tone, I'm autistic I have difficulty communicating "normally", no harm was intended.
17 Nov 2022 05:47 PM
@jamesn123 wrote:Im not looking for your connection stats I'm looking for the live Tx & Rx when your network is 'Idle' and then are running the speedtest to see if that bandwidth is making it through your WAN connection and whether there is any idle devices using bandwidth in the background.
I appreciate you may be tech minded and have a good understanding of how to look at these problems but its a bit silly post on a forum asking for help and then snap back at anyone who offers advice or to see some network test results.
I appreciate your input & apologise for my tone, I'm autistic I have difficulty communicating "normally", no harm was intended.
I've tested the Tx/Rx both when idle & when running 3 different speed tests, the same average 89Mbps is getting through.
The other connected devices can only physically use a few Kbps, being plus & bulbs.
Like I said, thanks for the input.
17 Nov 2022 05:47 PM
Posted by a Superuser, not a Sky employee. Find out more@ChrisKJ if you post the result confirming nothing else was running when tested I will add it to the list of cases.However do reportvthe issue to Sky as they cant directly link your account to a post.
17 Nov 2022 05:55 PM
Due to disability, I'll have to get someone round to remove & temporarily replace all the smart bulbs, the plugs I can reach.
However, this will cost me & I find it completely unnecessary, considering the tiny amounts of bandwidth these devices can possibly use.
If on day 13 the speed isn't nearer 145Mbps, than the average 89Mbps, I'll contact Sky to potentially cancel the contract, as per my cooling off period rights, unless they can correct the issue.
17 Nov 2022 07:19 PM
Thanks both for your help.
I've fixed the issue.
Openreach installed the fibre last week, he asked if I had an ethernet cable to go to the router, because there wasn't one in the box with the ONT, & asked if one should be provided, he said yes, then went & got one from his van, I'd just assumed, him being a network engineer, that he knew what he was doing.
I was wrong, he had fitted a Cat5 cable.
I just had a eureka moment & checked the only thing I hadn't previously checked & fitted a Cat6 from the ONT to the router.
Bang! 150Mbps on my phone & that's on WiFi, with 28 other devices still attached, just as it should be.
So due to my "irrelevant" knowledge & skills, I've sorted out my problem, that Openreach caused.
I'll again apologise to you both for my unintentional harsh tone, as explained above.
Cheers.
13 Jan 2024 10:33 AM
Hi I know that it was a while back you originally posted but as a fibre engineer I just wanted to point out that we don't get issued Ethernet cables Cat5 or CAT6. It is up to the customers internet provider to supply them. The engineer probably just had one in his van he gave you. If he hadn't you would have either needed to contact SKY to get one sent out or bought one yourself.
13 Jan 2024 11:24 AM
Posted by a Superuser, not a Sky employee. Find out more@Me1977 thank you that is useful to know. .
Sky normally send out a short Ethernet cable in the box with the hub or if the customer already has a SR203 hub they send a so-called "conversion kit" which is simply the Ethernet Cable on its own.
Just to clarify Cat5 cables should noot be used as its maximum speed is limited but Cat5e or above are fine for gigabit connections up to 100m. You would hard pushed to buy much anything else these days but using old cables out of drawers/vans can cause these issues. 😀
13 Jan 2024 12:01 PM
Totally agree. Unfortunately as an engineer the service providers cause all sorts of problems for us. Either no info to customers, wrong info, not sending out new cables or even new routers.
That's is why engineers collect
spare Ethernet cables to give to customers as they have usually lost the original they got with the router or the provider hasn't sent one out.
No problem. Browse or search to find help, or start a new discussion on Community.
On average, new discussions are replied to by our users within 4 hours
New Discussion