Discussion topic: Sky TV multiswitch “unearthed”
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Message posted on 22 Nov 2024 01:34 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report post
Sky TV multiswitch “unearthed”
Engineer has come now for a second visit where he couldn't find the multi switch. He's now found it although he said he can't carry out the work as it is unearthed?
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
All Replies
Message posted on 22 Nov 2024 01:43 PM - last edited: 22 Nov 2024 01:47 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report post
Re: Sky TV multiswitch “unearthed”
@br6 wrote:
Engineer has come now for a second visit where he couldn't find the multi switch. He's now found it although he said he can't carry out the work as it is unearthed?
hi @br6
Unfortunately that is the case - the engineers are not allowed to connect to unearthed equipment
It looks like the the bolt on the bottom right is where an earth cable should be connected
Edit: at closer look I am not too sure where it should be earthed - although my previous statement could be correct
Message posted on 22 Nov 2024 01:55 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report post
Re: Sky TV multiswitch “unearthed”
Thanks a lot, frustrating as it's now going to be about 3 months since I first ordered.
Message posted on 22 Nov 2024 02:06 PM - last edited: 22 Nov 2024 02:14 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report post
Re: Sky TV multiswitch “unearthed”
I will tag our knd expert @Godfrey to see if he can offer any advice.
(Edit : especially as I am not sure whether the connection at 1 is set to be the ground - I can't quite make out the manual image I have found)
Message posted on 22 Nov 2024 03:12 PM - last edited: 22 Nov 2024 03:18 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report post
Re: Sky TV multiswitch “unearthed”
This is where the earthing post is situated on a Triax T5 T512 multiswitch, I also suggest the use of earthing bars on all the input and output coaxial cables.
Illustration of a typical coaxial cable connection earthing bar fitted between a distribution device and the individual coaxial cables.
Godfrey.
Message posted on 22 Nov 2024 03:20 PM - last edited: 22 Nov 2024 03:25 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report post
Re: Sky TV multiswitch “unearthed”
Many thanks @Godfrey your image does make it clearer than the one I found 🙂
Edit : BTW it seems strange that there is such an earthing bar showing (which is where I first suspected was a suitable point) without being connected to any earth cable
@br6 Hopefully your buidling management will get their contractors to rectify this so that you can proceed in future
Message posted on 22 Nov 2024 05:50 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report post
Re: Sky TV multiswitch “unearthed”
Thanks guys. Strange that it wasn't done. It's about 7 years since they were developed, but hopefully management should still sort this. The only issue is that the mains enters in a separate building, so will need to be ran through a duct somehow to access that multiswitch. Headache.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page