New Update is now out.

[Jeffers27]

Yes they are , I'll try that whilst waiting until 9 to call them 

[Jeffers27]

Seems to have fixed it 

[SDR]

No BBC 1 schedule till 2:30 today just says waiting for schedule, also multiple gaps on tbe following days

BBC 1 in Scotland

Anyone else?

[Joe-Bow]

@oO0C4B4N4 You didn't happen to get the pre general release of the previous firmware did you?

[mally+01]

So what is the new software number

[SDR]

---

@mally+01 wrote:

So what is the new software number

---

2.08

[Joe-Bow]

@mally+01 2.08.  The very first post on the thread 😁

[Joe-Bow]

@oO0C4B4N4 Just forced mine and it worked.

[Joe-Bow]

Am liking View All at the start of the Playlists now 👍

[AJM1972]

Annoyingly in the TV guide you can no longer scroll up from BBC1 to see the UHD channels in order to check that the F1 is actually going to be recorded. You have to type in the channel number or scroll all the way to the bottom of the guide. 

[oO0C4B4N4]

@Joe-Bow Yes I did. I had the previous version a week or more before it was pushed out to everyone 

were you the same?

[Chrisee]

@SDR been playing with settings on my TV and the Auto backlight bug seems fixed the picture is brighter have set it to on in Movie mode for the time being to see how it goes. HDR looks better but definitely not the sets strong point. 

The bug where the motion sensor lost its settings seems fixed as does the Bass boost setting. Start up is a bit faster. Also not seen the slowdown catch up issue on over 4 hours viewing not sure if that is the update or changes at the server end as it seemed better before the update landed.

Been running through the apps and looking at the Amazon app as people were saying it is very grainy.  .i used the Wheel of Time via the Sky Glass app and via the LGC9's app and the picture shows no noticeable differences.

Not got the regional mix ups others have and the TV guide is fully populated just have to stop pressing select on the default as it loads the ITV restart option have to go right instead. Also quite like the rail for restart. 

All in all the new firmware is an upgrade fingers crossed we get the missing apps like Peacock and perhaps another firmware release before Sky freeze the code for Christmas. 

[Joe-Bow]

@oO0C4B4N4 Yes, I did too, so I was wondering if that was the cause of the issues?  I manually forced my updated this morning and is worked fine so thankfully this route works.

[oO0C4B4N4]

@Joe-Bow 

Did you just do a reset by pulling the power?

[Joe-Bow]

@oO0C4B4N4 @Yes, but keep your finger on the on/off button at the side while powering back on until the red led on the front starts blinking.  

Needed to reactivate and go through some of the setup process again, but everything was still there after the upgrade, except my custom settings for the Tv had been reset (I took a picture of them before though in case I needed to redo them), and I had to change the contrast in the accessibility section as I prefer the "dark mode" it gives me as it had set that back to default.

Picture looks good though from the outset so I'll need to take a good look to see if I need to change them.