Discussion topic: Engineer visit cable over roof ?
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Message posted on 15 Oct 2026 01:48 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report post
Engineer visit cable over roof ?
I've had the grey box installed outside on the back wall of my terrace house and the engineer is due on the 19th to connect me up but all the equipment it needs to connect to is in the front room.
So my Q is does anyone know if it's standard practice for them to put the cable over the roof and through the front wall because I hate the thought of having cables room to room. The Open Reach engineer said they'll do it but they may moan. Can anyone please help with this ? All advice appreciated
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
All Replies
Message posted on 15 Oct 2026 02:12 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report post
Re: Engineer visit cable over roof ?
@CatmadMark i would be surprised if the engineer will agree to throw the fibre pigtail,cable over a roof. Normally the ONT is instalked on the inside of the same wall the CSP box is on. You can extend the cable between the ONT and Sky hub using standatd Ethernet czble of Cat5e or higher but that is not something the engineer will do.
65inch Sky Glass, 3 Sky Streaming Pucks, Sky Ultrafast + and Sky SR213(white Wifi Max hub) main Wifi from 3 TP-Link Deco M4 units in access point mode
Message posted on 15 Oct 2026 04:57 PM - last edited: 15 Oct 2026 05:11 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report post
Re: Engineer visit cable over roof ?
@CatmadMark wrote:
does anyone know if it's standard practice for them to put the cable over the roof and through the front wall
That was never good practice for a copper connection and absolutely shouldn't be done with an optical circuit.
BT Halo 3+ Ultrafast FTTP (500Mbs), BT Smart Hub 2
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page