0
Discussion topic: IPV6 not working via eero and SR203
Reply
Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
This message was authored by: max+bank
Message posted on 07 Dec 2024 12:39 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report post
IPV6 not working via eero and SR203
I've got an eero 6 system connected to the SR203 with most of the settings changed to what the double NAT guide suggests.
https://helpforum.sky.com/t5/Broadband/Double-NAT-Setup-Guide/td-p/4256938
If I run the eero in bridge mode, the ipv6 test passes but if I set the eero to automatic the test fails. Somewhere, the ipv6 signal must be being blocked. I'm pretty sure I need automatic to allow port forwarding to a NAS as that gets disabled in bridge mode. The eero network shows it is capable of running ipv6 as well.
Has anyone else checked this, either running eero or maybe a Deco system?
Reply
Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page