topic Display does not support HDCP in Archive

Display does not support HDCP

santos2dog — Wed, 03 Nov 2021 13:10:30 GMT

Hi all - I've set up a TV eye which works fine as long as both TVs are on - as soon as I switch off the main tv the bedroom one shows the message 'Does not support HDCP'. I've turned off 'HDMI Control over RF' but still nothing.

Any ideas please?

Re: Display does not support HDCP

Mark39 — Wed, 03 Nov 2021 13:38:32 GMT

Try turning off HDMI Control as well.

Re: Display does not support HDCP

santos2dog — Wed, 03 Nov 2021 13:48:27 GMT

Hi Mark - I acrually had this problem a few months ago when I tested it internally with a couple of pre-made cables joined together - I posted it on here, got the solution (think it might even have been yours!) then forgot it by the time I had coax run around the outside of the house permanently.

Tried to find it on the DIscussion page but couldn't and can't find a way to search by one's own questions.

Found it eventually having posted the question again, apologies - for some reason the TV in the living room has to be switched off properly, not just via standby & the bedroom telly loses the error message and works fine.

Thanks for your response!

Re: Display does not support HDCP

Mark39 — Wed, 03 Nov 2021 15:03:14 GMT

@santos2dog no worries - that would be this thread: https://helpforum.sky.com/t5/Sky/Magic-eye-tv-turns-off-with-main-tv/m-p/3758506#M123214

I often remember posters' names but not in your case, apparently!